10
ENG
ENGLISH
ASSEMBLING AND PREPARING
Detaching the Stand Base
Screw Cover
Stand Body
S
tand Base
1
Place the screen face down.
y
To protect the screen from scratches, cover the
surface with a soft cloth.
CAUTION
2
3
Turn the screw to the left.
Pull out the Stand Base.
As shown in the illustration, pull Screw Cover out to
separate it from the set.
4
Remove the two screws on the back of stand body.
As shown in the illustration, disconnect the stand
body from the stand hinge.
1
2
y
Illustrations in this document represent typical
procedures, so they may look different from the
actual product.
y
Applying excessive force when tightening screws
may cause damage to the monitor. Damage
caused in this way will not be covered by the
product warranty.
y
Be careful not to hurt your hand on the edges of
the screw covers.
y
Do not carry the monitor upside down by just
holding the base. This may cause the monitor
to fall off the stand and could result in personal
injury.
y
When lifting or moving the monitor, do not touch
the monitor screen. The force applied to the moni-
tor screen may cause damage to it.
CAUTION
It may hurt your foot off the stand, so be careful.
CAUTION
To Next Page
Loading...
