14
ENGLISH
Installing the wall mount plate
This monitor supports the specification of the standard wall
mount plate or compatible device.
1
Place the screen face down. To protect the screen from
scratches, cover the surface with a soft cloth.
2
Place the wall mount plate onto the monitor and align it
with the screw holes.
3
Tighten the four screws to fix the plate to the monitor
using a screwdriver.
1
Place the monitor’s screen face down. To protect the
screen from scratches, cover the surface with a soft
cloth.
2
Remove the stand from the monitor by pressing the but-
ton on the bottom center of the back of the monitor.
y
The wall mount plate is sold separately.
y
For more information on installation, refer to the wall
mount plate's installation guide.
y
Be careful not to use excessive force when mounting
the wall mount plate, as this can damage the monitor's
screen.
NOTE
y
Use of the Kensington lock is optional. The
accessories can be purchased at your local electronics
store.
NOTE
Using the Kensington lock
The Kensington security system connector is located at the
back of the Monitor set.
For more information on installation and usage, refer to the
Kensington lock user manual or visit the website at http://
www.kensington.com.
Connect the Kensington security system cable between the
Monitor set and a table.
y
Take care when rotating the monitor if the cable is
connected.
y
To avoid injury when rotating the display, do not place
your fingers between the display and the stand base.
Detaching the Stand Body
WARNING
To Next Page
Loading...
