LG 32LC2D User Manual

APPENDIX
95
Programming a code into a remote mode
To find out whether your remote can operate the device without programming, turn on the device such as a
VCR and press the corresponding mode button on the remote.
After that, press the
PPOOWWEERR
button. If the device is turned off then it responds properly and the remote
need not to be programmed. If not, the remote should be programmed to operate the device. The program-
ming procedures are explained below.
Press the
MMEENNUU
and
MMUUTTEE
button continuously at the same time for 2 seconds, the current selected
device button will be illuminated.
If you don't press any button for 20 seconds, the light on the mode button will be turned off. In that case,
you have to repeat from step 2.
Enter code numbers using the number button on the remote by referring the code table on the following
pages. When pressing the button, the light blinks at a time. If the device turned off, the programming is
successful.
Press the
MMEENNUU
button to store the code. After blinking twice, this code is stored.
Test the remote functions to see if the device responds properly. If not, repeat from step 2.
The remote is a multi-brand or a universal remote. It can be programmed to operate most remote-control-
lable devices of other manufacturers.
Note that the remote may not control all models of other brands.
2
3
4
5
1
PROGRAMMING THE REMOTE CONTROL
9U0569A-2 Rev05 1/9/96 2:04 PM Page 95

LG 32LC2D Specifications