LGE LCD Division LG(51)
Establish:
Reform:
LC12C Adjust Specification
LG Electronics
R Gain j g 00 C0 TBD
G Gain j h 00 C0 TBD
B Gain j i 00 C0 TBD
R Cut TBD
G Cut TBD
Cool
B Cut TBD
R Gain j a 00 C0 TBD
G Gain j b 00 C0 TBD
B Gain j c 00 C0 TBD
R Cut TBD
G Cut TBD
Medium
B Cut TBD
R Gain j d 00 C0 TBD
G Gain j e 00 C0 TBD
B Gain j f 00 C0 TBD
R Cut TBD
Warm
G Cut TBD
5.1.5 Adj. method
5.1.5.1 Auto adj. method
1) Set TV in adj. mode using ADJ key
2) Zero calibrate probe then place it on the center of the Display
3) Connect Cable(RS-232C)
4) Select mode in adj. Program and begin adj.
5) When adj. is complete (OK Sing), check adj. status pre mode
(Warm, Medium, Cool)
6) Remove probe and RS-232C cable to complete adj.
▪ W/B Adj. must begin as start command “wb 00 00” , and finish as end command “wb 00 ff”,
and Adj. offset if need
5.1.5.2 Manual adj. method
1) Set TV in Adj. mode using ADJ key
To Next Page
Loading...
