LGE LCD Division LG(51)
Establish:
Reform:
LC12C Adjust Specification
LG Electronics
Measurement condition:
1. RF input: Mono, 1KHz sine wave signal, 100% Modulation
2. CVBS, Component: 1KHz sine wave signal 0.5Vrms
3. RGB PC: 1KHz sine wave signal 0.7Vrms
-----<<<8. Magic Romocon Test
- Equipment: RF-Remote Controller for Test, IR-KEY-CODE Remote Controller for Test.
- should have enough Battery Power of RF-Remote Controller before test.
(Recommend: changing new Battery for each LOT.)
- Test Method
a) Push “Mute (Start Key)” on the controller to pair the TV SET.
b) Push “OK Key” on the controller, check whether the cursor appears on the screen.
c) Push “Vol+(STOP) on the controller, cancel the paring.
>>>>>----
9. 3D Function test
(Pattern Generator MSHG-600 or MSPG-6100 HDMI 1.4 Supported Equipment
, HDMI mode No. 872 , pattern No. 83)
1) Input 3D test pattern.
(HDMI mode No. 872, Pattern No. 83)
2) After automatically display 3D OSD, push the OK Key.
To Next Page
Loading...
