LG 47LW6500 - Option Selection Per Country; Tool Option Selection; GND and Internal Pressure Check

LGE LCD Division LG(51)
Establish:
Reform:
LC12C Adjust Specification
LG Electronics
6 seconds, R/G/B value is not lower than 10, replace Eye Q II sensor
Step 5) Remove your hand from the Eye Q II sensor and wait for 6 seconds
Step 6) Confirm that “ok” pop up.
If change is not seen, replace Eye Q II sensor
5.3 Option selection per country
5.3.1 Overview
▪ Option selection is only done for models in Non-USA North America due to rating
▪ Applied model: LC12C Chassis applied None USA model (CHINA ,HONGKONG)
5.3.2 Method
1) Press ADJ key on the Adj. R/C, then select Country Group Menu(TBD)
2) Depending on destination, select KR or US, then on the lower Country option, select US,
CA, MX. Selection is done using +,
- KEY(TBD)
5.4 Tool Option selection
▪ Method: Press Adj. key on the Adj. R/C, then select Tool option.
Model Tool 1 Tool 2 Tool 3 Tool 4 Tool 5 Tool 6
42LW6500-CA(HK)
33030 5397 3327 17577 48725 5830
47LW6500-CA(HK)
33032 5397 3327 17577 48725 5830
55LW6500-CA(HK)
33035 5397 3327 17577 48725 5830
47LW6500-CA(CN)
33032 5397 3263 17569 48721 5830
55LW6500-CA(CN)
33035 5397 3263 17569 48721 5830
6. GND and Internal Pressure check
6.1 Method
1) GND & Internal Pressure auto-check preparation
- Check that Power Cord is fully inserted to the SET.