watching to a USB HDD, so you can play back any scenes you might miss while
watching TV. This function allows you to continue watching from where you were
previously if you go out for a while.
The Live Playback function can be used only for broadcast programmes you view through
the antenna input terminal. However, you cannot use this option while listening to a radio
programme.
Select a device to be used with Live Playback when two or more USB HDDs are connected
to the TV.
You cannot use a USB stick. Connect a USB HDD with 80 GB or more of total storage.
If there is not enough remaining space in the USB HDD device, Live Playback may not
work properly. To use Live Playback function, you need the USB HDD which has at least
2.3 GB.
With the Live Playback function, you can play a programme back for up to two hours
depending on remaining USB HDD capacity. This time may vary depending on your region.
The videos saved in Live Playback mode are deleted if you turn off the TV without recording
them.
Input the USB HDD in the USB port.01
Press the button on the remote control and select Live Playback.
If your remote control does not have a button, press and hold the button.
02
The Live Playback setting confirmation screen appears.
Complete the settings and press the OK button.
If only one USB storage device is connected, the settings screen may not appear and
Live Playback may run.
03
During watch the live broadcast, select a point on the progress bar which you want
by the pointer. You can also press the / buttons on your remote control to use
this feature.
Select a previous point than the current point on the progress bar.
04
To Next Page
Loading...
Need help?
General
