Operating 19
Operating
3
Setting the alarm
You can use the unit as an alarm clock.
You have to set the clock before setting the alarm.
1. Turn the unit on.
2. Press and hold TIMER. Alarm sound sources will
blink.
3. Select the one you want and press TIMER to
save.
(TUNER/CD/USB)
4. “ON TIME” will be displayed. This is your desired
time to the unit turns on.
Press
C
/
V
to change the hours and
minutes and press TIMER to save.
5. The “OFF TIME” will be displayed. This is your
desired time to the unit turns off.
Press
C
/
V
to change the hours and
minutes and press TIMER to save.
6. Press
C
/
V
to change the volume and
press TIMER to save.
7. You can check the setting status.
8. If you want to reset the alarm, repeat steps 2-6.
y
If you have activated the alarm before, you
can check alarm information by pressing
TIMER in stand by mode.
y
In power-on mode, press TIMER to
deactivate alarm
y
In power-on mode, press TIMER to activate
alarm. Then you can see alarm information
and alarm icon
.
,
Note
Sleep Timer Setting
Press SLEEP repeatedly and ENTER to select delay
time between 15 and 90 minutes. After the delay
time, the unit will be turned o. (You can see the
following order, 15 ->30 -> 45 -> 60 -> 90->OFF)
To cancel the sleep function, press SLEEP
repeatedly until “SLEEPOFF” appears.
y
You can check the remaining time before
the unit is turned o.
y
Press SLEEP. The remaining time appears in
the display window.
,
Note
Dimmer
Press DIMMER once. The display window will be
darkened by half. To cancel it, press DIMMER once
more.
CM2030-DU_AESPLLB_ENG.indd 19 2013-06-19 3:08:57
To Next Page
Loading...
Need help?
General
