POWER ON
FLD “NO DISC” status
It is possible at any function.
(ex. It is possible at FLD “NO USB” status, too.)
This is an example.
Remote control ‘ ’ + Front ‘STOP’
push same timing during 5 seconds.
FLD “op0-…..”
Move to appropriate position and
make changes with remote control.
( , , , REPEAT)
Press STOP key
FLD “WRITE OK”
Remote control ‘ ’ +
Front ‘STOP’ push same timing.
FLD “e2p clr”
Completed
1-7
SERVICE INFORMATION FOR EEPROM
To Next Page
Loading...
