③
Unscrew the screws from the lower cover.
②
The cabinet cover clamp is removed by special jig for
service and the gasket is released.
③
Two screws are unscrewed.
④
Unscrew all the screws on the upper and lower sides
of the CABINET COVER.
① The plate assembly(Top) is disassembled.
② Pull out the drawer and unscrew 2 screws.
③ Lift the side the Control Panel Assembly and
pull it out
①
Two screws is unscrewed.
②
Push out PANEL ASSEMBLY,CONTROL after Push
the hook(
①, ②
) below.
To Next Page
Loading...
Need help?
General
