27OPERATION
ENGLISH
2 Set the number of degrees to adjust :
• Press or press and hold plus (+) or minus (-)
c until the desired number of degrees
appears in the display.
• Press Settings to indicate whether the
temperature should be increased (+) or
decreased (-).
• The temperature adjustment is shown next
to
AdJU d.
• You can adjust the temperature up or down
by 35 °F or 19 °C.
3 Press START e to accept the change.
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be adjusted by ±35 °F (±19
°C).
• Once the temperature is adjusted, press
Settings repeatedly until
AdJU is displayed to
see the amount you adjusted and change it if
needed.
• The temperatures displayed by an oven
thermometer placed in the oven cavity may
differ from the actual set oven temperature in all
modes.
Turning the Preheat Alarm Light On/
Off
When the oven reaches its set-temperature, the
preheating alarm light flashes 5 times or until the
oven door is opened.
You can activate or deactivate the preheating
alarm light.
1 Press Settings repeatedly until PrE appears in
the display.
2 Press plus (+) or minus (-) to turn the light on/
off.
3 Press START to accept the change.
Adjusting the Beeper Volume
1 Press Settings repeatedly until 8EEP appears
in the display.
2 Press plus (+) or minus (-) to select the
desired volume.
3 Press START to accept the change.
• Adjusting the beeper volume does not affect the
preheat alarm volume.
Selecting Fahrenheit or Celsius
Set the oven temperature display to show either
Fahrenheit (℉) or Celsius (℃) units. The oven
defaults to Fahrenheit unless changed by the user.
1 Press Settings repeatedly until UNit appears
in the display.
2 Press plus (+) or minus (-) to select F
(Fahrenheit) or C (Celsius).
3 Press START to accept the change.
Turning the Wi-Fi On/Off
You can turn the Wi-Fi transmitter on the PCB on
or off.
1 Press Settings repeatedly until Wi-Fi appears
in the display.
2 Press plus (+) or minus (-) to turn the Wi-Fi
transmitter on/off.
3 Press START to accept the change.
Control Lock
The Control Lock feature locks the control panel,
but does not lock the oven door.
• When the Control Lock feature is activated, the
cooktop does not operate.
1 Press and hold Control Lock for three
seconds.
en-us_main.book.book Page 27 Wednesday, March 27, 2024 11:27 AM
To Next Page
