15
Reference
Troubleshooting
Cause
• The power cord is disconnected.
•
The audio cables are not connected
securely.
• The power of the external source
equipment is switched off.
• The speaker cable is set to a wrong
position.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the guide.
• The disc is dirty.
• The remote control is not pointed at the
remote sensor of the unit.
• The remote control is too far from the
unit.
• There is an obstacle in the path of the
remote control and the unit.
• The batteries in the remote control are
exhausted.
Correction
• Plug the power cord into the wall outlet
securely.
• Connect the audio cable into the jacks
securely.
• Switch on the external source
equipment.
• Set the speaker cable to the correct
position, then turn on the unit again by
pressing POWER.
• Insert a playable disc.
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Point the remote control at the remote
sensor of the unit.
• Operate the remote control within about
23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.
Reference
Symptom
No power
No sound
The unit does not
start playback
The remote
control does not
work properly
To Next Page
Loading...
