Sleep Timer Setting
Press SLEEP one or more times to select delay
time between 10 and 180 minutes, after the
unit will turn o.
To cancel the sleep function, press SLEEP
repeatedly until “SLEEP 10” appears, and then
press SLEEP once again while “SLEEP 10” is
displayed.
NOTE
You can check the remaining time before the
unit turns o.
Press SLEEP. The remaining time appears in the
display window.
Dimmer
Press SLEEP once. The display window will
be darken by half. To cancel it, press SLEEP
repeatedly until dim o.
Radio Operations
Be sure that both FM and AM aerials are
connected. (Refer to the page 13)
Listening to the radio
1. Press FUNCTION until FM or AM (MW)
appears in the display window.
The last received station is tuned in.
2. Press and hold
TUNING (-/+) for about
two seconds until the frequency indication
starts to change, then release. Scanning
stops when the Unit tunes in a station.
or
Press
TUNING (-/+) repeatedly.
3. Adjust the volume by rotating
MASTER
VOLUME on the unit or by pressing
VOLUME (+/ - ) on the remote control
repeatedly.
Presetting the Radio Stations
You can preset 50 stations for FM and AM
(MW).
Before tuning, make sure that you have turned
down the volume.
1. Press
FUNCTION until FM or AM (MW)
appears in the display window.
2. Press or rotate to select a desired frequency;
- On the remote control: TUNING (-/+)
- On the unit:
MULITI JOG DIAL or ı<</>>ı
3. Press
PROG./MEMO. a preset number will
ash in the display window.
4. Press
PRESET/FOLDER (
/
) to select the
preset number you want.
5. Press
PROG./MEMO.
The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. Press to select a preset station;
- On the remote control:
PRESET/FOLDER
or 0 to 9 numerical buttons
- On the unit:
I
PRESET - / PRESET +
i
Deleting all the saved stations
1. Press and hold PROG./MEMO. for two
seconds.
“ERASE ALL” will ash up on the unit display.
2. Press
PROG./MEMO. to erase all saved
radio stations.
Improving poor FM reception
Press PLAY (
B
/
X
) (ST./MO) on the unit or on
the remote control. This will change the tuner
from stereo to mono and usually improve the
reception.
To Next Page
Loading...
