24 Troubleshooting
Troubleshooting
6
6
Troubleshooting
PROBLEM CAUSE CORRECTION
General
No Power.
The power cord is not plugged in. Plug in the power cord.
Check whether electricity failed.
Check the condition by operating other
electronic devices.
No sound
Check whether you select right function.
Press FUNCTION and check the
selected function.
If not, connect speaker cables correctly. Speaker cables connected correctly.
CD
The unit does not
start playback.
An unplayable disc is inserted. Insert a playable disc.
No disc is inserted. Insert a disc.
The disc is dirty. Clean the disc. (Refer to the 23 page)
The disc is inserted upside down.
Place the disc with the label or printed
side facing upwards.
RADIO
Radio stations
cannot be tuned
in properly.
The antenna is positioned or connected
poorly.
Connect the antenna securely.
The signal strength of the radio station is
too weak.
Tune to the station manually.
No stations have been preset or preset
stations have been cleared (when tuning
by scanning preset channels).
Preset some radio stations, see page
17 for details.
Remote
control
The remote
control does not
work properly.
The remote control is too far from the unit.
Operate the remote control within
about 23 ft (7 m).
There is an obstacle in the path of the
remote control and the unit.
Remove the obstacle.
The batteries in the remote control are
exhausted.
Replace the batteries with new one.
TAPE Unable to record.
Record protect tabs are removed.
Cover holes on back edge of tape with
tap.
To Next Page
