8 _ Dip Switch & Group Control Setting
Dip Switch &
Group Control Setting
Group Control Setting
- This function is only for group control.
- Please don’t set this function in case of non-group control.
- This function is the Master or Slave setting function of indoor unit
- Set only one indoor unit to Master, set the others to slave.
- After setting Group Control of the product, turn off the power then turn it back on after 1 minute.
- Master checking whether the buzzer sounds, such as indoor rings below.
▶ Master: “Beep” (Buzzer sound 1 time)
▶ Slave: “Beep, Beep, Beep, Beep, Beep ” (Buzzer sounds 5 times)
No. Function
Function Code
Setting Value Remote Controller LCD
0 Mode Override
0 : Set to Master
1 : Set to Slave
1 : Standard
1
2 : Low
3 : High
4 : Super High
0 : Set to Master
Group Control 1 : Set to Slave
2 : Check Master/Slave
3 : Set to Auxiliary heater
4 : Cancel Auxiliary heater
2 : Check Auxiliary heater Installation
Installer Setting Code Table
0
1
2
Ceiling Height
Selection
Auxiliary
heater
2
00
01
11
12
13
14
20
21
22
23
24
25
2
To Next Page
Loading...
Need help?
General
