Using Instant Recording
To end the recording, press the button on the remote control during recording and
select Record.
Matters That Require Attention of Recording
While recording, press the Wheel (OK) button to display information about the recording.
The Wheel (OK) button operation may vary depending on the country.
You can set recording time before the recording starts, and during the recording, you can
change the time by selecting the Record button.
Because of the content protection technology used, the recorded video cannot be played
on PCs or other TV models. Also, the video cannot be played if the TV’s video circuit is
replaced.
Do not remove the USB cable while recording.
If you force your TV to power off while recording, the recorded content may not be saved.
Ideally, you should stop the recording and check that the programme has been recorded
before turning the TV off.
During recording, you can watch the other programmes or use the other functions.
However, you can only use the programme you are recording and free programmes while
recording a scrambled programme.
(Some models may not be supported.)
Connect a USB HDD or USB stick to a USB port.
It is recommended that you record to a USB HDD.
01
Press the button on the remote control and select Record.
If your remote control does not have a button, press and hold the button.
02
You cannot change programme modes while recording.
●
When connected to one satellite signal :
●
To Next Page
Loading...
Need help?
General
