Code Item Detail Remark
12 Value #2 Note Lower limit of setting range(FCU is not equipped)
Default 16 °C
Range 16 ~ 18 °C
13 Function Setting air temperature in heating mode
Description Adjusting range of 'Setting Air Temperature' in heating mode
Value #1 Note Upper Limit of setting range
Default 30 °C
Range 24 ~ 30 °C
Value #2 Note Lower Limit of setting range
Default 16 °C
Range 16 ~ 22 °C
14 Function Setting
Heating flow
temperature in heating mode
Description Adjustin range of 'Setting
Heating flow
Temperature' in
heating mode
Value #1 Note Upper Limit of setting range
Default 57 °C
Range 35 ~ 57 °C
Value #2 Note Lower Limit of setting range
Default 15 °C (*20 °C)
Range 15 ~ 34 °C (*20 ~ 34 °C)
15 Function Setting DHW tank heating flow temperature for
Sanitary water heating
Description
Adjusting range of 'Setting DHW tank heating flow Temperature'
in Domestic hot water tank heating mode
Value #1 Note Upper Limit of setting range
Default 50 °C
Range 50 ~ 80 °C
Value #2
Note Lower Limit of setting range
Default 40 °C
Range 30 ~ 40 °C
18 Function Screed drying mode
Description
After installing water pipes for under floor heating, user can select
screed drying mode for curing the cement
Value #1 Note
Default 01
Range 00 ~ 01
Value #2 Note
Default -
-
Range -
'Setting DHW
tank heating flow
Temperature' is
used when user
wants to set water
temperature of
Domestic hot
water tank.
00: Screed drying mode is not connected and not used.
01:Remote air sensor is connected and used.
'Setting air
temperature' is
used when user
wants to set
target
temperature by
room air
temperature.
'Setting Heating
flow temperature'
is used when
user wants to set
target tempera-
ture by
Heating flow
(from the unit)
temperature.
* : Electric heater
is not used
System Set-Up
80 Air-to-Water Heat Pump
To Next Page
Loading...
