Operation Setting
10 Air-to-Water Heat Pump
You can easily control the desired operation mode.
In the main screen, press [<, > (left/right)] button to select the operation mode or home leave or hold
category, and press [∧ , ∨ (up/down)] button to set the operation mode.
※ Some products may not support some operation modes.
This mode is only applied to heating.
In order to save energy and to give highest comfort, setting temperature will follow outside tempera-
ture. If outdoor temperature decreases, heating capacity for the house will increase automatically in
order to keep same room temperature. All parameters will be set by installer during start-up proce-
dure and will be adapted to the site characteristic.
1. Select AI / Auto mode.
Operation mode
AI / Auto operation
Operation Setting
Mode Description
Cool The product yields cool water to use in FCU cooling.
Heat The product yields hot water to use in under floor heating or FCU heating.
AI / Auto
In this mode, heating setpoint is automatically determined by pre-defined
temperature profile.
To Next Page
Loading...
Need help?
General