EasyManuals Logo

LG UN64 Series User Manual

LG UN64 Series
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
ENGLISH
54
SoftAP
(Depending on model)
SoftAP is similar to Access Point. When this value is On, Wi-Fi Service application is displayed at the launcher bar. SoftAP is activated when user selects
On in the Wi-Fi Service application.
Regardless of the Instant On mode, the SoftAP setting stays unchanged after power off/on. (Depending on model)
Use Default
If you want to use default password(this password was generated randomly), you must select ‘Enable’ in this item.
Security Key
If you want to change default password, you need to change ‘Use Default’ value into ‘Disable’.
Wi-Fi Signal Strength
You can control wireless signal strength on SoftAP. This is controlled by 5 step. If you select ‘Not Used’, wireless signal strength will be set to Max value.
Wi-Fi Channel
You can control the wireless channel in SoftAP mode. It is controlled by 1 to 11 channels(2.4GHz). The 5GHz channel is controlled by the channel
supported by the country where it is set. However, DFS channels cannot be set. If you select’Auto’, the SoftAPs wireless channel is set to a random
channel.
Mode
(Depending on model)
You can select NAT(Network address translation) mode and Bridge mode for Soft AP.
Security Type
(Depending on model)
This menu is activated only when Bridge mode is selected.
Type of security authentication protocol required for wireless connectivity
WPA2-PSK, 802.1X EAP, and OPEN are available from this menu.
Radius Server IP, Radius Server Port, Radius Server Key
(Depending on model)
This menu is activated only when Bridge mode is selected and 802.1X EAP is selected.
If you want to use 802.1X, you must enter the IP address of the authentication server that manages the user’s credentials, as well as the Port and Key
information.
VLAN ID
(Depending on model)
This menu is activated only when Bridge mode is selected.
SoftAP VLAN ID is needed when you want to separate TV packets and SoftAP packets.
The packets via SoftAP are tagged when the packets go through LAN port to external network.
It is not compatible with Network VLAN ID. (SoftAP VLAN is not available if LAN port or AUX port in VLAN ID is set.)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG UN64 Series and is the answer not in the manual?

LG UN64 Series Specifications

General IconGeneral
BrandLG
ModelUN64 Series
CategoryLED TV
LanguageEnglish

Related product manuals