22
CLEANING THE DUST BIN
1. Open the dust bin cover by pressing the PUSH button
on the Roboking.
2. Grab the handle of the dust bin and pull it upward.
3.
Separate the HEPA filter and the inside sponge filter by
removing the HEPA filter
※ To clean the dust bin filter, refer to page 23.
4. Lift the cover upward while pressing the separation
button on the dust bin.
5. Empty the dust bin and clean it with a cleaning brush
or under running water.
6. After cleaning with water, completely dry the dust bin
in a well-ventilated area out of the direct sunlight.
7. When you have completed cleaning the dust bin, close
the cover and replace the sponge filter and HEPA filter.
8. Put the dust bin into the Roboking and close the dust
bin cover.
If the dust bin is full, suction power can be weakened. Clean the dust bin before and after each cleaning ses-
sion. Clean the dust bin using the following sequence:
• After cleaning, always mount the dust bin filters (HEPA filter, sponge filter) to the dust bin. If
they are not mounted, dust may enter the Roboking interior and cause product failure.
• Always close the dust bin cover. If attempt to operate the Roboking while the cover is open, you
will hear a voice message stating “Please check the dust bin.”
Tip
To Next Page
Loading...
Need help?
General
