18
CLEANING MODES
수동 청소
수동 청소
When the START button on the main unit or the remote
control is pressed, Roboking operates in the spatial ex-
pansion cleaning mode.
Roboking first runs the zigzag cleaning mode and then switch-
es to spatial expansion mode by dividing the space by partial
squares to clean inside the house thoroughly.
1. Press the ZIGZAG+Cell by Cell button on the remote con-
trol. Zigzag cleaning and then spatial expansion’
2. Roboking cleans total of 6m area in zigzag cleaning mode
by cleaning up to 3m on the left side until it hits the wall.
3. After cleaning in the left direction, Roboking returns to the
starting point and cleans in the right direction until it hits
the wall to clean total area of 6m to complete the zigzag
cleaning mode.
4. And then Roboking switches to the spatial expansion clean-
ing mode, which is the automatic cleaning mode.
Spatial expansion cleaning
Zigzag cleaning and then spatial expansion button
• The cleaning mode can only be changed with the remote control.
Tip
The 1st stage:
A maximum area of 3 m x 3 m (9.84 ft x
9.84 ft) will be cleaned. (The actual size
of the area will change in accordance
with the shape of the house’s interior.)
The 2nd stage:
The inside of the area will be cleaned in
a zigzag path.
When the 1st and 2nd stages are completed, the device
will move to the next cleaning area and repeat the stages
until the entire inside of the house has been cleaned.
To Next Page
Loading...
Need help?
General
