26
CLEANING THE SIDE BRUSH
Foreign objects/materials such as hair can easily adhere to the side
brush. Remove such materials at least once a week.
If excessive amounts of foreign materials are stuck to the brush, there is
the risk of breakage.
If the floor is rough or walls are frequently cleaned, the side brush may bend or become damaged. In this
case, use the following method to straighten the side brush.
1. The following procedure is helpful in restoring de-
formed brushes.
2. Turn off the power supply by pressing the
START/STOP button on the Roboking for two
seconds.
3. Place the Roboking at the end of a table to make
cleaning the side brush easier. Make sure that the
Roboking is not in danger of falling.
4. Soak the side brush in warm water.
5. Press the side brush for about ten seconds so that it
is completely submerged in the water.
6. Slowly wipe the side brush by sliding it through your
hand.
7. Rotate the side brush and repeat steps 4-6 for each
section of the brush.
8. Use the side brush only after it has completely dried.
To Next Page
Loading...
Need help?
General
