25
Receiving sensor of
remote controller
• Do not clean the Roboking by directly spraying it with water, thinner, benzene, etc.
• Call the service center if the sensor or charging terminal is damaged. Sensor and terminal
damage can cause the product to malfunction.
There are sensors on the Roboking that can detect obstacles, stairways and the
home station for charging the battery. In order to maintain the performance of
the Roboking, regularly clean the sensors and charging terminal as follows:
1. Lay a smooth cloth on the floor, overturn the Roboking and put it on the
cloth.
2. Turn off the power switch on the bottom of the Roboking. Injury can be
caused by the activation of the Roboking during cleaning.
3. Use a smooth cloth or cleaning brush to wipe the dust off each sensor and
the charging terminal as described below.
CLEANING THE SENSOR/CHARGING TERMINAL
Charging terminal
Obstacle detection sensor
Cliff detection sensor
Charging terminal
Lens
Tip
To Next Page
Loading...
Need help?
General
