23
The dust bin filters are comprised of the HEPA filter and the sponge filter.
Clean the HEPA filter and the sponge filter according to the following sequence:
1. Separate the HEPA filter and the inside
sponge filter by removing the HEPA
filter.
3. After washing the HEPA filter and the
sponge filter with water, place them out
of direct sunlight and allow them to dry
completely.
4. Mount the cleaned HEPA filter and sponge
filter into the dust bin according to the
sequence shown to the right. When assem-
bling the filter, the filter handle should face
upward.
2. Carefully clean any fine dust off the HEPA
filter and the sponge filter with a vacuum
cleaner or water.
• In order to maintain the performance of the Roboking, the HEPA filter should be cleaned with
a cleaning brush or vacuum cleaner at least once a week, and should be washed under running
water at least once a month.
CLEANING THE DUST BIN FILTER
Tip
To Next Page
Loading...
Need help?
General
