LG WM1377HW Series - Connecting the Water Lines

I N S TA L L AT I O N I N S T R U C T I O N S
CONNECTING THE WATER LINES
3
Attach the hot water line to the hot water
faucet. Attach the cold water line to the cold
water faucet.
Tighten the fittings securely. Open the water
faucets fully to check for leaks.
Water Tap
NOTE:
UÊÊÀÊÞÕÀÊÃ>viÌÞ]Ê>`ÊvÀÊiÝÌi`i`Ê«À`ÕVÌÊ
life, use only authorized components. The
manufacturer is not responsible for product
malfunction or accidents caused by the use of
separately purchased, unauthorized parts.
UÊÊ1ÃiÊiÜÊÃiÃÊÜiÊÞÕÊÃÌ>ÊÌiÊÜ>Ã}Ê
machine. Do not reuse old hoses. Use only the
inlet hoses provided with the washer. LG does
not recommend the use of aftermarket hoses.
UÊÊ*iÀ`V>ÞÊViVÊÌiÊÃiÃÊvÀÊVÀ>VÃ]Êi>ÃÊ
and wear, and replace the hoses every 5 years.
UÊÊÊÌÊÃÌÀiÌVÊÌiÊÜ>ÌiÀÊÃiÃÊÌiÌ>Þ]Ê>`Ê
make sure that they are not crushed by other
objects.
UÊÊ7>ÌiÀÊÃÕ««ÞÊ«ÀiÃÃÕÀiÊÕÃÌÊLiÊLiÌÜiiÊ£{°xÊ
psi and 116 psi (100~800 kPa). If the water
supply pressure is more than 116 psi, a pressure
reducing valve must be installed.
UÊÊ/Ê«ÀÛ`iÊ«ÌÕÊÜ>Ã}Ê«iÀvÀ>ViÊÌiÊ
hot water temperature should be set at 120-
135°F (48-57°C) and the cold at 60°F (15°C).
NOTE: Do not cross-thread the hose fittings.
Attach the hot water line to the red hot water
inlet on the back of the washer. Attach the
cold water line to the blue cold water inlet on
the back of the washer. Tighten the fittings
securely.
1
Hot water tap
Cold
water
tap
Water
Inlets
11
Insert a rubber seal into the threaded
fittings on each hose.
2
Rubber Seal
Water Hose
(to tap)
Rubber Seal
Water Hose
(to water inlet
on washer)
or
Rubber Seal
Water Hose
(to water inlet
on washer)