WM2496H*M Page 13 of 58 TRAINING MANUAL
ACCESSORIES
The washer comes with the two input hoses. The blue stripe is for cold water and
the red stripe is for hot water. While the hoses appear to be mechanically
identical, the temperature and pressure ratings are different. It is critical to the
performance of the washer to have the hot and cold hoses connected correctly.
The wrench is used to remove (and replace) the shipping bolts and to adjust the
leveling feet. Be sure to leave it and encourage the customer to retain the wrench,
the four shipping bolts, and the manual in a safe place in the event the washer
requires service or the customer moves.
The shipping bolts MUST BE REMOVED before operating the washer. (See
page 15.) Also check for the packing block, which sometimes remains in the
base when the washer is unpacked.
To Next Page
Loading...
