WM2496H*M Page 49 of 58 TRAINING MANUAL
DISASSEMBLY/REPAIR (Damper)
1. Disconnect the dampers from
the tub and the base.
(See photos, left.)
Be sure to press in the safety
tab before pushing the pin out
of the damper. You can use a
9
/
16
” socket to hold the pin in
while you squeeze the pin with
the special tool 383EER4003A.
(See page 58.)
2. The flat end goes on the small
end and the split end allows the
head end to pass through while
the pin is pushed out.
The color and/or appearance of
the dampers may vary by model.
3. Use special tool 383EER4003A
to remove the damper pins. If
you are replacing the dampers,
you’ll have to remove both
ends. If you are removing the
tub for major repair work,
disconnect the damper ends at
the base and leave the other
ends connected until you
remove the tub. When putting
the tub back into the machine,
connect the dampers to the tub
first. It is much easier that way.
4. Be careful not to pull the
dampers apart while they are
disconnected from the machine.
To Next Page
Loading...
