WM2496H*M Page 42 of 58 TRAINING MANUAL
DISASSEMBLY/REPAIR (Door)
Remove the door with the front cover
still on the machine.
1. Open the door.
2. Remove seven screws from the
hinge cover.
3. Pry off the hinge cover with a
flat screwdriver.
4. Remove the screw at the bottom
of the hinge.
5. Lift the door off the hinge.
CAUTION! The door is HEAVY!
DISASSEMBLY/REPAIR (Door switch removal)
1. Open the door.
2. Remove the gasket clamp using
special tool 383EER4001A.
(See page 58.)
3. Remove the two screws holding
the switch.
4. Push the gasket aside to
remove the switch.
5. Unplug the switch to change it.
6. Make sure the wires don’t fall
back in before you can replace
the switch.
To Next Page
Loading...
