TRAINING MANUAL WM3001H*A
WM3001H*A Page 14 Washer
ACCESSORIES
The washer comes with the two input hoses. The blue stripe is for cold water and the red
stripe is for hot water. The hoses are not mechanically identical. It is critical to the
performance of the washer to have the hot and cold hoses connected correctly. The hot
hose is a thicker material suitable for higher temperatures and pressure.
The wrench is used to remove (and replace) the shipping bolts and to adjust the leveling
feet. Be sure to leave it and encourage the customer to retain the wrench, the four
shipping bolts, and the manual in a safe place in the event the washer requires service or
the customer moves. Your wrench may vary from the drawing; some wrenches may have
an extra hole in them for features in another market.
The shipping bolts MUST BE REMOVED before operating the washer. (See page 15.)
The wrench, shipping bolt hole covers,
drain hose tie-down strap, and a sample
packet of detergent are included in
a packet shipped inside the washer.
See page 36 concerning detergent usage.
Pay attention to the “RULE of TWOs.”
To Next Page
Loading...
