LG WM3001HRA - Test Mode Display Interpretation

TRAINING MANUAL WM3001H*A
WM3001H*A Page 52 Washer
TEST MODE
The steam washer must be empty and off to enter the test mode.
1. Press and hold SPIN SPEED and SOIL LEVEL.
2. Press POWER. The buzzer will sound twice.
3. Press START/PAUSE to cycle through the test modes. (See chart, below.)
Number of times
Start/Pause pressed
Event Display
None All lamps on LOAD TEST MODE
1 Door locked LOAD TEST MODE
2 Drain pump/Tumble clockwise
rpm
1
(42 ~ 50)
3 Spin – Low speed
rpm
1
(35 ~ 45)
1
4 Spin – High Speed
rpm
1
(110 ~ 117)
1
5 Pre-wash valve (Cold)
Water level freq. (0 ~ 255)
2
6 Main wash valve (Cold)
Water level freq. (0 ~ 255)
2
7 Main wash valve (Hot)
Water level freq. (0 ~ 255)
2
8 Steam valve (Cold)
Water level freq. (0 ~ 255)
2
9 Bleach valve (Cold)
Water level freq. (0 ~ 255)
2
10 Tumble counterclockwise
rpm
1
(42 ~ 50)
1
11 Tub heater (1.2 seconds)
Water temperature (tub) °C
12 Circulation pump
Water level freq. (0 ~ 255)
2
13 Drain pump
Water level freq. (0 ~ 255)
2
14 Steam generator level sensor
Water level freq. (0 ~ 255)
2
15 Water level sensor ( steam)
Water temperature (TSG) °C
16 Off NORMAL OPERATING MODE
Notes:
1. Insert a zero at the end of the displayed numbers larger than two
digits to determine the actual rpm. 62 indicates either 62 or 620 rpm;
115 indicates 1,150 rpm.
2. Water levels are displayed as a frequency; this is interpreted by the main
board as a water level but is meaningless to humans.