TRAINING MANUAL WM3001H*A
WM3001H*A Page 42 Washer
DISPENSER
Remove the top plate (cover.)
(See page 40.)
Remove the dispenser drawer.
Remove the two screws that secure the
dispenser body.
Remove the 5 hose clamps. If you squeeze
them and slide them a couple of inches
down the hose, they will not be lost while
the repair is made. Reconnection will be
more convenient if you mark the hoses
now. See TEST MODE (page 52) for
information concerning verifying which
hose is which.
Remove the clamp on the large hose
attached to the dispenser. (When you
replace it, set it with the screw on top and
the wing nut on the bottom for easier
reach in the future.)
Unplug all the solenoids. (As with the
hoses, reconnection will be more
convenient if you mark the connectors
and valves now.)
Remove the two screws at the back of the
machine and lift out the solenoid array.
# CONN WIRE COLORS
1 Blue (Yellow and Black)
2 Red (Violet and Black)
3 White (White and Black)
4 Blue (Gray and Black)
5 Red (Blue and Black)
To Next Page
Loading...
