Need help?Do you have a question about the LG WM3001HRA and is the answer not in the manual?
Provides critical safety information for servicing the appliance, emphasizing authorized use and modifications.
Warns about electrical shock hazards and the weight of appliances during servicing.
Details connecting hot and cold water inlet hoses correctly.
Specifies the 120 VAC, 60 Hz, 20-amp circuit requirement for the steam washer.
Provides essential safety precautions before commencing any service work.
Presents the overall block wiring diagram of the washing machine.
Identifies and labels the various connectors on the main control board.
Details the steps for disassembling and repairing the control panel assembly.
Explains how to access and disconnect the main control board.
Provides instructions for removing and servicing the dispenser assembly.
Details the procedure for removing the front cover of the machine.
Continues instructions for removing the front cover.
Provides steps for removing and servicing the door and its hinges.
Details the removal and servicing of the pump and filter assembly.
Provides instructions for removing and testing the wash heater element.
Details the process of removing and reinstalling the motor.
Guides on the major procedure of removing the tub/drum assembly.
Describes how error codes are displayed and the machine's response.
Lists common error codes, symptoms, and potential causes.
Details the LE error code, its causes, and troubleshooting steps.
Details troubleshooting steps for inlet valve errors.
Provides a troubleshooting flowchart for drain errors.
Details resistance and voltage checks for the drain pump.
Guides on checking the rotor magnet and stator resistance.
Details checks for the door switch assembly and PCB.
Details checks for the main PWB LED and display PWB.
Guides on checking the display PCB and physical buttons.
Guides on checking vibration sensor terminals and connectors.
Details how to test the noise filter using a multimeter.
Describes the process and conditions for locking the door.
Provides detailed ohm and voltage testing methods for the hall sensor.
Presents wiring diagrams for heater driver circuits.
Details resistance testing for the wash thermistor at various temperatures.
To Next Page
General
