TRAINING MANUAL WM3001H*A
WM3001H*A Page 20 Washer
INSTALLATION (Pedestal, new style, continued)
Insert the T-clip of the four retainers into
the dryer base, as shown.
Press up on the back of the clip and pull
outward to lock it into place.
Set the dryer on the pedestal.
(The dryer feet fit the innermost holes in
the mounting brackets.)
Make sure the screws on the pedestal align
with the holes in the retainers.
Attach two screws in each retainer to
attach the dryer to the pedestal. Tighten
them without stripping them; the brackets
are plastic. If the screws are not tightened
correctly, noise and vibration may result.
Turn each leg on the dryer ¼ turn to put a
little pressure between the dryer and
pedestal to eliminate vibration.
Push the dryer and pedestal into their
place. Then level the dryer by adjusting the
front leg(s). When it is level, lock down the
adjuster lock nuts.
To Next Page
Loading...
