TRAINING MANUAL WM3001H*A
WM3001H*A Page 16 Washer
CONNECTIONS
WATER
Be sure the rubber washer is inside the hose end. Attach the hoses to the washer
(red is HOT, blue is COLD). Tighten them firmly but don’t strip the plastic threads on
the washer connections. The hoses are clearly marked by temperature. The HOT hose is
thicker and has a higher temperature rating and burst strength.
DRAIN
The drain pipe should be firmly attached to the standpipe or the laundry tub or sink
where it drains. The pump has sufficient power to cause the pipe to move around when
the water is expelled. The pump can lift the drain water a maximum of 96 inches (2.4 m),
but there is no minimum height requirement. The vacuum breaker in the drain line will
prevent drainage by gravity or siphoning. The hose can lay flat into a floor drain as long
as the end of it is not submerged.
ELECTRICAL
The steam washer requires a 120 VAC, 60 Hz., dedicated, 20-amp circuit.
To Next Page
Loading...
