IMPORTANT SAFETY INFORMATION
USING THE MAGNETIC SAFETY KEY
WARNING: The magnetic safety key MUST be in place before the equipment can
be used as a treadmill.
NOTE: The equipment can be used as a walking pad at speeds less than 3.5 mi/hr
without the safety key.
The error code “E7” will show on the display until the magnetic safety key is in
place on the magnetic port on the front of the treadmill console. If the safety key is
removed from its port during training, the treadmill will stop automatically and cannot
be restarted until the safety key is back in position.
WHAT TO DO IN AN EMERGENCY
WARNING: You must wear the magnetic safety key clipped to your clothing every
time you use the treadmill.
• Stop training immediately if you realize that you cannot keep up with the pace, if
you start feeling sick, or if any other emergency arises.
• Keep the remote control watch on your hand or on the tray during the training
session in case you need to press the Stop button to stop the treadmill quickly.
• If you trip during training, you can easily step off the treadmill onto the floor, as
the treadmill is small and low to the ground.
• It’s a good idea to practice quickly and safely getting off the treadmill so that you
will know what to do if you trip, lose your balance, or an emergency arises.
• Make sure that all third parties are familiar with the safety instructions.
DISABLING THE TREADMILL FOR SAFETY
To prevent the treadmill from being used by unauthorized users, always remove the
magnetic safety key and power cord when you have finished training. Keep the safety
key and power cord stored in a separate place, out of reach of unauthorized people,
especially children. Never leave children unattended in the same room with the
treadmill, especially when it is connected to power.
DURING EXERCISE
• Keep your body and head facing forward at all times.
• Make sure to breathe regularly and calmly during exercise.
• Stay hydrated before, during, and after exercise.
• Wear light, comfortable clothing and well-fitting, dirt-free athletic shoes. Do not wear
loose clothing that could become caught in the treadmill and result in falling or injury.
• Check your pulse regularly and stop if it becomes too high.
8 OmniFit Trimotion User Manual Lifepro
TREADMILL SETUP GUIDE
SETUP WARNINGS:
• Adult setup is required. Keep children away during setup.
• Properly dispose of all packaging especially plastic bags, which can present a
suffocation hazard to small children, before setup.
• Ensure you have at least a 6 by 6 foot space around you for setup.
• Assembly requires two people since the treadmill is bulky and heavy.
• Always use proper lifting techniques as the treadmill is quite heavy.
NOTE: Your treadmill comes pre-lubricated. You do not need to lubricate the
running belt before using it for the first time.
SAFE PLACEMENT OF YOUR OMNIFIT TRIMOTION TREADMILL
• Only operate and store the OmniFit Trimotion on a flat, non-slip floor.
• Ensure the running deck is level to the ground. If the deck is positioned on an
uneven surface, it could cause damage to the electrical system.
• Set up with at least 7 feet of clearance from walls and furniture at the back
and at least 4 feet of clearance at the front and sides of the treadmill.
• Do not use outdoors or in high-moisture or high-temperature environments.
• If setting up in a carpeted room, check underneath the treadmill to ensure
clearance between the carpet and the running deck. If there is not enough
clearance, or you’re not sure, place a mat or rug under the OmniFit Trimotion.
Ensure the mat or rug is at least 60” × 36” and will not slip during use.
Endurance Training Collection 9
LAY OUT THE TREADMILL PARTS AND HARDWARE
1. Place the folded body of the treadmill on a flat floor.
2. Place all of the hardware and tools nearby.
1
To Next Page
Loading...
General
