INSTALLING THE MEDIA TRAY
CAUTION:
• Do not stare down at reading material or electronic devices for long
periods while the running belt is moving to avoid injury or falling.
• Do not jog or run at speeds over 3.5 miles per hour while using the media
tray. Running while reading or engaged in a video can be hazardous.
• Do not place heavy objects or lean on the media tray, which is only meant
to hold a few pounds.
1. Slide the handrails out from
under the display console as
shown in Figure 1.
2. Locate the red latch under the
media tray. See Figure 2.
3. Slide the media tray over the
two handrails while pulling the
red latch. See Figure 3.
4. When you hear a clicking noise, indicating the tray is locked in place,
release the red latch.
5. Ensure the tray is locked securely in place.
MEDIA TRAY SETUP GUIDE
USING YOUR TREADMILL
READY THE OMNIFIT TRIMOTION
1. Flip the Power switch on the front to the ON
position. The display will light up.
2. Place the safety key onto the yellow magnetic
port on the front of the treadmill.
3. Clip the other end of the safety key securely to your clothing.
GET ON THE TREADMILL
1. Stand with your feet on the foot rails, one foot on either side of
the running belt.
2. Press the Start/Stop button on the control panel or the
Start button on the remote control. Wait for the 3-second
countdown.
3. As the treadmill begins to move, begin walking along the
running belt.
1
GET OFF THE TREADMILL
1. Press the Start/Stop button on the control panel or the
Stop button on the remote control to stop the running
belt.
2. Wait until the treadmill has come to a complete stop
before removing the safety key and getting off the
treadmill.
POWER OFF AND UNPLUG THE OMNIFIT TRIMOTION
1. Once the treadmill is stopped, flip the Power switch to the
OFF position.
2. Unplug the power cord.
2
2
1
STARTING THE TREADMILL
STOPPING THE TREADMILL
OFF
ON
Figure 1
Figure 2 Figure 3
14 OmniFit Trimotion User Manual Lifepro Endurance Training Collection 15
To Next Page
Loading...
Need help?
General
