USING THE DISPLAY PANEL
The display panel is located on the front of the treadmill near your feet. It
alternates showing time, distance, calorie, and speed, as indicated by the
corresponding illuminated LED.
CAUTION:
• Do not stare down at the display panel for long periods while the running
belt is moving to avoid injury or falling.
• It’s best not to stand on the display panel, speaker, or motor housing.
1. Display Window: Alternates between showing the time elapsed,
distance run, calories burned, and speed.
2. Time Indicator LED: Indicates the value shown in the display window is
the running time elapsed in minutes and seconds (0 to 99 minutes) or
the time remaining until your training time goal is reached.
3. Distance Indicator LED: Indicates the value shown in the display
window is the distance run (0 to 99 miles) or the distance remaining
until your training distance goal is reached.
4. Calorie Indicator LED: Indicates the value shown in the display window
is the number of calories burned (0 to 990 calories) or the calories
remaining until your calorie goal is reached.
5. Speed Indicator LED: Indicates the value shown in the display window
is the speed in mi/hr (0.5 to 7.5 mi/hr).
6. Speaker: Emits sound. Pair with your Bluetooth device if desired.
TIME
SPEED
DIS.
CAL.
1 2 43 5
6
ADJUSTING THE INCLINE
You can manually adjust the OmniFit Trimotion to be used flat or at an
incline. There is only one incline setting available.
WARNING: This step requires two people; the treadmill is heavy and
bulky.
NOTE: The OmniFit Trimotion has a lock pin on each wheel that is used for
stability when storing. You may leave these in place or remove and store
them.
To raise the front of the treadmill:
1. Remove the lock pins from both wheels.
2. Lift the front corner of the treadmill.
3. Have the second person flip the wheel down to the position shown.
4. Return the treadmill to the floor.
5. Repeat steps 2-4 for the other side.
6. Inspect the treadmill to see if it is level and sturdy. Each of the four
feet and the two wheels should touch the floor.
7. If needed, adjust the height of any feet that are not touching the floor
by twisting them counterclockwise.
18 OmniFit Trimotion User Manual Lifepro Endurance Training Collection 19
To Next Page
Loading...
Need help?
General
