LifeSafety Power FlexPower Netlink NL4 - User Manual

LifeSafety Power, Inc. | PH 888.577.2898 | TechSupport@LifeSafetyPower.com
P03-37 Rev A12
Netlink® Communication Modules
Installation and Operation

LifeSafety Power FlexPower Netlink NL4 Specifications

General

Brand	LifeSafety Power
Model	FlexPower Netlink NL4
Category	Control Unit
Language	English

Summary

Notes and Warnings

General Safety Warnings

Crucial safety warnings regarding installation, operation, and environmental factors.

Section 1 - Installation

1.1 Mounting the Netlink Module

Step-by-step guide for physically installing the Netlink module in an enclosure.

1.2 Netlink Module Components Overview

1.3 Connecting the Netlink Module

Instructions for connecting power, Ethernet, and devices to the Netlink module.

Section 2 - Initial Configuration

2.1 Preparing to Configure the Netlink

Steps and requirements for setting up a computer to configure the Netlink board.

2.2 Configuring the Netlink Board

Detailed steps for logging in, changing passwords, and initial board setup.

2.2.3 Time and Network Settings

2.2.5 SNMP Settings Configuration

2.2.6 Email Settings Configuration

2.2.9 Netlink Module Settings Configuration

2.2.10-2.2.11 Sensor Calibration & User Settings

2.2.15 Import and Export Configuration File

Section 3 - Using the Netlink Board

3.1 Viewing System Parameters

3.2 Accessing and Programming Devices

Viewing detailed information and programming parameters of connected power supplies and M8 boards.

3.3 Using the Tools Page

Appendix 2 - NS2 Board