LifeSafety Power FLEXPOWER NetLink NLX

LifeSafety Power, Inc. | PH 888.577.2898 | TechSupport@LifeSafetyPower.com
P03-37 Rev A12
Netlink® Communication Modules
Installation and Operation

LifeSafety Power FLEXPOWER NetLink NLX Specifications

General

Brand	LifeSafety Power
Model	FLEXPOWER NetLink NLX
Category	Control Unit
Language	English

Summary

Section 1 - Installation

1.1 Mounting the Netlink Communication Module

Step-by-step guide for mounting the Netlink module into a LifeSafety Power enclosure.

1.2 Netlink Network Communication Module Overview

1.3 Connecting the Netlink Network Communication Module

Guides on connecting power, Ethernet, and devices to the Netlink module.

1.3.4 Connecting the Current Sensor(s)

1.3.5 Connecting the Event Input

1.3.7 Connecting the ADC (Voltmeter) Input

1.3.8 Wiring the Control Outputs

1.3.9 RS485 Port (NLX only)

Section 2 - Initial Configuration

2.1 Preparing to configure the Netlink board

Details prerequisites and steps before configuring the Netlink board.

2.2 Configuring the Netlink board

Guides on logging in, resetting, and configuring various settings for the Netlink.

2.2.1 Logging into the Netlink for the first time

Guides on initial login, password change, and factory reset procedures.

2.2.1.1 Resetting the Netlink

Explains how to reset Netlink to factory defaults for username, password, and IP address.

2.2.2 Configuring the TCPIP Settings

Covers TCP/IP settings for network integration and connectivity.

2.2.3 Time Settings

Explains how to set time and date using manual entry, sync with computer, or NTP server.

2.2.5 Configuring the SNMP Settings

Guides on configuring SNMP settings for network monitoring and trap receivers.

2.2.6 Configuring the Email Settings

Explains setup for email alerts and periodic status reports.

2.2.9 Configuring the Netlink Network Module Settings

2.2.15 Import and Export Configuration File

2.2.19 Setting up the Parameters for the Email Reports

Section 3 - Using the Netlink Board

3.1 Viewing System Parameters on the Netlink Home Page

3.2 Accessing and Programming Connected Devices

Guides on viewing and configuring parameters for connected devices.

3.2.1 Power Supply Management

Details monitoring, testing, and setting up power supply parameters.

3.3 Using the Tools Page

3.4 Understanding The Email Report

Appendix 2 - NS2 Board

A2.1 Mounting the NS2 Output Controller Accessory

A2.2 NS2 Module Overview

A2.3 Wiring the NS2