To Next Page

To Previous Page

Netlink Installation and Operation Manual

ii iii

Table of Contents

Notes and Warnings ......................................iii

Symbol Deﬁnitions ............................................................ iii

Warnings.................................................................... iii

Regulatory Information ......................................................... iii

Conventions Used Within this Manual.............................................. iii

Introduction............................................iv

Section 1 – Installation ....................................1

1.1 Mounting the Netlink Network Communication Module ..............................1

1.2 Netlink Network Communication Module Overview..................................2

1.3 Connecting the Netlink Network Communication Module .............................4

Section 2 – Initial Conﬁguration .............................. 8

2.1 Preparing to conﬁgure the Netlink ..............................................8

2.2 Conﬁguring the Netlink.......................................................9

Section 3 – Using the Netlink............................... 21

3.1 Viewing System Parameters on the Netlink Home Page.............................21

3.2 Accessing and Programming Connected Devices..................................23

3.3 Using the Tools Page .......................................................30

3.4 Understanding The Email Report ..............................................31

Appendix 1 – Software Agreement ........................... 32

Appendix 2 - NS2 Board .................................. 34

i Manual covers Firmware Rev 9.32

Older ﬁrmware revisions may not have all features described. See the latest ﬁrmware release notes at http://www.lifesafe-

typower.com/support/software-ﬁrmware-downloads

i Resetting the Netlink

If the user name or password is unknown for a Netlink board, press and hold the reset button located next to the backup

battery for 10 seconds to return these values to default. Pressing the reset button for 30 seconds will also reset the IP

address, certiﬁcate, and Cipher Suite to default. See section 2.2.1.1 for more information.

i Upgrading Netlink Firmware

The browser history / cache should be cleared after performing the ﬁrmware upgrade and before accessing the Netlink again

to prevent any cached pages from giving outdated information. See Section 3.3 for detailed steps for ﬁrmware upgrades.

LifeSafety Power FLEXPOWER NetLink NLX User Manual

Questions and Answers: