To Next PageTo Next Page
Need help?Do you have a question about the LifeSafety Power FlexPower Vantage R8 series and is the answer not in the manual?
General| Input Voltage | 120/240 VAC, 50/60 Hz |
|---|---|
| Number of Outputs | 8 |
| Output Voltage | 12 or 24 VDC |
| Output Current | 8A |
| Battery Charging Current | 4A |
| Efficiency | 85% |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Dimensions | 4.5" D |
| Certifications | UL 1481 |
| Features | Network monitoring |
Details FPV4 models with 4 amp outputs, fused or Class II.
Details FPV6 models with 6 amp outputs, fused or Class II.
Details FPV102 models with 10 amp @ 12VDC, fused or Class II.
Details FPV104 models with 10 amp @ 24VDC, fused or Class II.
Explains common symbols used in the manual for installer safety and important information.
Lists critical safety warnings for installation and service personnel to prevent hazards.
Step-by-step guide for securely mounting the power supply enclosure to a wall.
Details AC voltage selection jumpers and primary AC connection for the FPV4.
Explains AC ON LED, FAI LED, Flex IO, and auxiliary connections for the FPV4.
Describes FAI/Charge Current switches, FAI input, fault contacts, and main DC output.
Covers AC input, voltage selection jumpers, and terminal blocks for FPV6, 102, 104.
Details AC ON LED, FAI LED, Flex IO, and auxiliary connections for these models.
Explains FAI/Charge Current switches, fault contacts, and main DC output for FPV6, 102, 104.
Describes FlexIO, B1/B2/BR connectors, and zone input terminals on the R8 module.
Details zone output terminals, relay state LEDs, and output voltage LEDs on the R8 module.
Explains dry output selection jumpers and output fuse/PTC configurations for the R8 module.
Details the FAI LED indicator and FAI selection switches for controlling zone unlock behavior.
Guide for connecting various input sources (NO relay, DC ground, open collector) to the R8 module.
Explains the use of NC, C, NO, and COM terminals for voltage or dry contact outputs.
Instructions for removing output diodes to configure R8 module zones for dry contact output.
Details how to activate and deactivate the FAI input using relay contacts or voltage.
Explains latching FAI input and overriding FAI with AC fault status.
Describes how to wire a tamper switch for enclosure monitoring to the system.
Provides general guidelines for physical installation and routing of power limited and non-power limited wiring.
Electrical and mechanical specifications for the FPV4-R8E1 model.
Electrical and mechanical specifications for the FPV6-R8E1 model.
Electrical and mechanical specifications for the FPV102-R8E1 model.
Electrical and mechanical specifications for the FPV104-R8E1 model.
Specifications for the R8 accessory board's power input, zone input, and zone output.
Provides general installation requirements applicable to various system configurations.
Specific requirements for UL1076 proprietary burglar alarm system installations.
Specific requirements for S319 access control system installations.
Guidance on configuring locking devices for fail-safe operation under UL compliance.
