EasyManua.ls Logo

LifeSpan Power - Lubrication Procedures

LifeSpan Power
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
On a monthly basis, vacuum underneath your treadmill to prevent dust
build up. Once a year, you should remove the black motor shield and
vacuum out dirt that may accumulate.
6.3 General Care
Check parts for wear before use.
Pay particular attention to the fixing knobs and make sure they are tight.
Always replace the mat if worn and any other defective parts.
If in doubt do not use the treadmill and contact our helpline.
TAKE CARE TO PROTECT CARPETS AND FLOOR in case of leakages. This product
is a machine that contains moving parts which have been greased / lubricated
and could leak.
6.4 Belt/Deck/Roller Lubrication
The mat/deck friction may play a major role in the function and life of your
treadmill and that is why we recommend you constantly lubricate this friction
point to prolong the useful life of your treadmill.
Lubrication should be
applied after approximately the first 50 hours of operation. We recommend
lubrication of the deck according to the following timetable:
Light use (less than 3 hours per week) every 6 months
Medium use (3-5 hours a week) every 3 months
Heavy use (more than 5 hours per week) every 6-8 weeks.
See below procedures for lubricating:
1. Use a soft, dry cloth to wipe the area between the belt and deck.
2. Spread lubricant onto the inside surface of belt and deck evenly (make sure
the machine is turned off and power is disconnected).
- 10 -

Related product manuals