When an adjustment is made to the belt tension, you must also make a tracking
adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature
bearing failure.
6.7 Belt Tracking Adjustment:
This treadmill is designed to keep the belt reasonably centred while in use. It is
normal for some belts to drift near one side while the belt is running with no
one on it. After a few minutes of use, the belt should have a tendency to centre
itself. If during use, the belt continues to move toward one side, adjustments
are necessary. The procedures are as below:
▲ first set speed at lowest position.
▲ second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using
6mm Hexagonal Wrench, until the belt is centered itself; If belt shifts to left,
tighten the left bolt and loosen the right bolt by using 6mm Hexagonal Wrench,
until the belt is centered. When adjusting the belt using the 6 mm Hexagonal
Wrenches, it is important to adjust the belt in half turn increments. Over
adjusting the belt can cause damage to the mat.
7. Guides for malfunction
7.1 Analyzing and eliminating malfunction
Item. Malfunction Reasons Solution
The safety key isn’t in
the right position
Put the safety key in the
right position
The electrical switch is
placed to “0”
Turn the electrical switch to
“1”
1 Treadmill can’t be
started
Creepage switch is
not right
Replace creepage switch
2 Meter can’t display The meter control line
and control panel are
unconnected
Pull the bolt out and open
the motor cover and
reconnect it
- 12 -
To Next Page
Loading...
