Lifetime 90192 - Final Assembly: Filling the Base; Option A: Filling with Sand


TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
(375 lb)
./(!2$7!2%2%15)2%$&/24()30!'%
SEC
6.3
4WOADULTSAREREQUIREDTOCOMPLETEASSEMBLY4OPREVENTSERIOUSINJURIESTHE
0OLESHOULDBEHELDDOWNBYONEADULTATALLTIMESWHILETHE"ASEISBEINGlLLED
/04)/.!&),,).'7)4(3!.$
(416 lb of sand required)
a. Fill the "ASE!*- with sand.
b. Screw the "ASE#AP!*. onto the fi ll hole.
c. Using two adults, stand the Base up on a smooth surface.
7!2.).'
For safety reasons, we recommend that sand be used
instead of water to fi ll the Base. If a leak develops, water
could run out unnoticed, allowing the system to fall over,
resulting in serious personal injuries, or property damage.
If using Water, check the Base carefully for leaks. If a
leak is found, lay the system down on the ground and
call Customer Service. Do not use, stand up, or play on
a leaking system.
!*-