8.Faulty Isssue 8: the PAN/TILT direction out of step, no position correct, bad synchronization
Troubleshooting:
◎ Check if the PAN/TILT sensor are covered with too much dust , clean it water-free alcohol.
◎ Check if the PAN/TILT sensor are damaged. when POWER ON, manually move the Pan/ Tiltbut
no reset, it means the PAN/TILT sensor are damaged, then replace the new ones.
◎ The wrong distance between the PAN/TILT senor and sensor data reading wheel, the sensor
data reading wheel should be in the middle position, and no scrape, no collide, no rub.
◎ For outdoor use, check if there is water appears on the sensor data reading wheel, which would
cause PAN/TILT issue.
◎ Check if the cable of PAN/TILT motors are loose and bad contact.
◎ Check if the PAN/TILT belt is too tight, aging or loose, adjust or replace the belt.
◎ When PAN/TILT position is deviate from original, please enter into Display board MENU, and the
adjust steps are as followings: SERVICE—Adjust—Pan or Tilt, adjust it , Exit it.
7
To Next Page
Loading...
