Lighthouse REMOTE-4PN Series Operating Manual
2-8 248083317-1 Rev 4
Please refer to the “Data Cable Build” on page 2 of “Getting Started”
(Chapter 3) for detailed instructions for terminating Cat5, Cat5e or
Cat6 cabling for use with this connector. Parts for completing this task
are available from Lighthouse if they were not provided with the order
or have been damaged and need to be replaced.
Annual Calibration
The manufacturer recommends that the Lighthouse instrument be
calibrated annually by a Certified Lighthouse Service Provider to
ensure that it continues to perform within specification.
When Calibration comes due, the Service LED will illuminate and stay ON
during sampling mode until the instrument has been calibrated.
Table 2-6 Ethernet RJ-45 Pinouts
Ethernet RJ-45 Pin Description Signal Name
1 White/Orange Rx+
2 Orange Rx-
3 White/Green Tx+
4 Blue Reserved for Future Use
5 White/Blue Reserved for Future Use
6 Green Tx-
7 White/Brown Reserved for Future Use
8 Brown Reserved for Future Use
To Next Page
Loading...
