Lighthouse REMOTE-4PN Series Operating Manual
4-6 248083317-1 Rev 4
Ethernet
Configuration
The Ethernet REMOTE-4PN comes pre-
configured to use DHCP and receive an IP
address automatically. If this is not a
desired configuration, use this section to
change these settings.
If the user does not understand the terms
used or the possible impact of changing
the REMOTE-4PN’s settings, do NOT
proceed without contacting the facility’s IT
personnel.
The following procedure requires a pre-
approval and planning by the IT
department and a joint setup effort.
Please Note: The Ethernet version of Lighthouse Worldwide Solutions REMOTE-4PN
instrument uses MODBUS ASCII over Ethernet. Connecting a REMOTE-4PN particle
counter directly to an Ethernet network should only be done with the permission and
guidance of the network administrator.
To Next Page
Loading...
