Lighthouse REMOTE-4PN Series Operating Manual
4-10 248083317-1 Rev 4
• Parity: None
• Stop Bits: 1.
• Press the OK button to save the settings. Serial Settings will display
Done! See Figure 4-6.
Figure 4-6 Serial Settings
6. As shown in Figure 4-7, select Connections and verify that
Connect Protocol and Connection settings are set to the following:
• Protocol: Modbus
• Local Port: 502
• Accept Incoming: Yes.
• Under Modbus Mode, set the Message Timeout to “1000ms” if
not already set.
• Press the OK button. Connections Settings will display Done! as
To Next Page