Lighthouse Remote 3014PN - Page 8

Lighthouse REMOTE-4PN Series Operating Manual
t-ii 248083317-1 Rev 4
Data Cable Install ................................................................................. 3-12
Pump Remote Cable Install ................................................................. 3-14
Energize Connections .......................................................................... 3-14
Understanding the LEDs .................................................................................. 3-15
Chapter 4 Communication Set Up
Definitions of Terms Used ............................................................................................. 4-1
REMOTE-4PN Communication Modes ........................................................................ 4-2
Communicating with the Instrument .................................................... 4-2
Data Port ............................................................................................................ 4-2
RS232 Communications .................................................................................... 4-4
RS485 Communications .................................................................................... 4-4
Connecting to a PC ............................................................................................ 4-5
Ethernet Configuration .................................................................................................. 4-6
Lantronix Software Use ................................................................................................. 4-7
Preparing for Network Installation .............................................................................. 4-12
Equipment Required: ....................................................................................... 4-12
Software Required: .......................................................................................... 4-12
Additional Requirements: ................................................................................ 4-12
Configure Device ......................................................................................................... 4-12
Ethernet REMOTE-4PN Configuration ........................................................... 4-12
Straight-through Cat5/Cat6 Setup: ....................................................... 4-13
Cross-over Cat5/Cat6 Setup: ............................................................... 4-14
Program the Interface ................................................................................................... 4-14
Windows Telnet Programming: ....................................................................... 4-14
TIA568A and TIA568B wire Examples ...................................................................... 4-19
Connect REMOTE-4PN to Ethernet LAN .................................................................. 4-19
Connect Ethernet Cable to Instrument ............................................................. 4-19
Chapter 5 Programming with MODBUS Protocol
DIP Switches .................................................................................................................. 5-1
Protocol Settings ............................................................................................................ 5-1
Power On/Auto Start ...................................................................................................... 5-1
Running the Instrument Using MODBUS ..................................................................... 5-2
AUTOMATIC Counting Mode ......................................................................... 5-2
MANUAL Counting Mode ................................................................................ 5-3
Configuring with the MODBUS Protocol ..................................................................... 5-4
Setting the Real Time Clock .............................................................................. 5-4
Changing the Default Instrument Parameters .................................................... 5-5
Using Sensor Setting Registers .............................................................. 5-5
Location (Register 40026) ..................................................................... 5-6
Hold Time (Registers 40031, 40032) .................................................... 5-6
Sample Time (Registers 40033, 40034) ................................................ 5-6