Lighthouse Remote 3014PN - Page 81

Index
248083317-1 Rev 4 I-3
Register Map B-2
Remote Monitoring 2-2, 3-9
RS-232 Communications 4-4
RS-232/485 IN Port 4-2
RS485 4-4
RS-485 Communications 4-4
RS485 converter 4-4
Running the Instrument Using MODBUS 5-2
S
Safety 1-1
Electrostatic safety information 1-2
Laser safety information 1-1
Sample Time 5-6
SAMPLING LED 3-15
Save 5-2
Sensor Settings Registers B-2
Location 5-6
Sample Time 5-6
Using Sensor Setting Registers 5-5
Set adapter’s IP address 4-16
Setting the Real Time Clock 5-4
Shielded Twisted Pair (STP) cable 3-2
Shipping instructions 3-1
Size Ranges 2-3, 2-4, 2-5, 2-6
Specifications 2-3, 2-4, 2-5, 2-6
Start command 5-2, 5-3
Start Pump 5-2
Stop command 5-2, 5-3
Stop Pump 5-2
Storage Temp/RH 2-3, 2-4, 2-5, 2-6
Straight-through Cat5 4-12
Straight-through Cat5 Setup 4-13
Subnet 4-1
Subnet Mask 4-9
Supported MODBUS Commands B-1
T
TCP/IP 4-1
Telnet 4-1
Telnet Programming 4-14
Tubing Kit for Remote Monitoring 2-2, 3-9
U
Understanding the LEDs 3-15
Unique non-zero address 4-5
Unpacking 3-1
Unshielded Twisted Pair (UTP) 3-2
Use of Lantronix Software 4-7
V
Vacuum 2-3, 2-4, 2-5, 2-6
W
Warning
Electrostatic Discharge 1-2
Infrared Radiation 1-1
LAN-connect 1-2
Relay Mode setting B-4
Weight 2-3, 2-4, 2-5, 2-6
Z
Zero Count Level 2-3, 2-4, 2-5, 2-6